This programs is for stock's administration and manages the cut operations to obtain ordered pieces with proper size and minimum loses. If you have stocks' profiles of any kind, as pipes, boards, wires, cornier, iron strips. metallic profiles, beams, bars, bales of textil material, wire fence, steel, iron, timber, flat iron, channels, rods, columns, steel angles, reinforced concrete or any other kind of linear items you must use StockSmash 1D to minimize the waste. Materials like those are tipically available in standard lenghts. Then the problem is how to cut it in such a way that the number of cutting stock material needed is minimal. When the requirement is very small (and quite simple) a clever man can be successful in performing the calculation. But, when the requirement is too complex and large it will be an extremely difficult and time consuming task. StockSmash is the ideal solution. In general the average wastage of money and material involved in bar cutting lies within the range of 5-15 %. Computer programs like those, can successfully bring down the wastage to a figure less than 1%.